Chrysler Cirrus/Stratus/Sebring/Avenger/Breeze 1995-1998

Window Regulator

Imprimir

REMOVAL & INSTALLATION



Power and manual window regulators are removed and installed using the same procedure.

2-Door Vehicles
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the door trim panel and watershield, as described earlier in this section.
  4.  
  5. If equipped with power windows, detach the wire connector from the power window motor.
  6.  
  7. Unfasten the nuts securing the regulator lift channel to the door glass.
  8.  
  9. Secure the window in the upright position.
  10.  
  11. Matchmark the position of the rear bolt of the roller channel to the inner door panel for installation purposes.
  12.  
  13. Remove the bolt securing the rear of the roller channel to the door panel.
  14.  
  15. Loosen the bolt holding the front of the roller channel to the door panel.
  16.  
  17. Separate the roller channel from the door panel.
  18.  
  19. Loosen the bolts holding the window regulator to the inner door panel.
  20.  
  21. Separate the bolt heads from the keyhole slots in the inner door panel.
  22.  
  23. Remove the window regulator through the large hole in the inner door panel.
  24.  
  25. If equipped, remove the power window motor from the regulator.
  26.  

To install:
  1. If equipped, install the power window motor on the regulator.
  2.  
  3. Move the regulator into position in the door, then engage the bolt heads into the keyhole slots in the inner door panel and tighten the bolts.
  4.  
  5. Install the roller channel to the door panel.
  6.  
  7. Install the bolt at the rear of the roller channel, making sure to align it to the mark on the inner door panel made during removal.
  8.  
  9. Tighten the front and rear roller channel bolts.
  10.  
  11. Install the nuts holding the regulator lift channel to the door glass.
  12.  
  13. If equipped, attach the electrical connector to the power window motor.
  14.  
  15. If equipped, install the door speaker.
  16.  
  17. Install the watershield and door trim panel.
  18.  
  19. Connect the negative battery cable.
  20.  

4-Door Vehicles
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the door trim panel and watershield.
  4.  
  5. Remove the window glass.
  6.  
  7. If equipped with power windows, detach the wire connector from the power window motor.
  8.  
  9. Remove the nuts securing the top of the regulator to the inner door panel.
  10.  
  11. Remove the nuts holding the bottom of the regulator to the door panel.
  12.  
  13. Loosen the bolts holding the regulator crank/motor to the door panel.
  14.  
  15. Disengage the bolts from the keyhole slots in the door panel.
  16.  
  17. Remove the window regulator from the access hole in the door panel.
  18.  
  19. Remove the power window motor from the regulator, if equipped.
  20.  

To install: