Chrysler Colt/Vista 1990-1993 Repair Information

Driving Device

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front and rear scuff plates.
  4.  
  5. Remove the center pillar corner garnish and upper and lower trims.
  6.  
  7. Remove the front pillar and flange trims.
  8.  
  9. Remove the shoulder belt tongue plate.
  10.  
  11. Disconnect the release switch connector and seat belt wiring harness connector.
  12.  
  13. Remove the outer casing and guide rail mounting bolts.
  14.  
  15. Remove the driving device assembly from the vehicle.
  16.  

To install:
  1. Fit the motor and rail assembly into the vehicle.
  2.  
  3. Install and torque the mounting bolts to the specified torque.
  4.  
  5. Reconnect the release switch connector and seat belt wiring harness connector.
  6.  
  7. Install the shoulder belt tongue plate, front pillar and flange trims.
  8.  
  9. Install the center pillar corner garnish and upper and lower trims.
  10.  
  11. Install the front and rear scuff plates.
  12.  
  13. Reconnect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo