Chrysler Colt/Vista 1990-1993 Repair Information



Brake pads and shoes contain asbestos, which has been determined to be a cancer causing agent. Never clean the brake surfaces with compressed air! Avoid inhaling any dust from brake surfaces! When cleaning brakes, use commercially available brake cleaning fluids.

The brakes should be bled whenever a brake line, caliper, wheel cylinder, or master cylinder has been removed or when the brake pedal is low or soft. The bleeding sequence is, left rear wheel, right front wheel, right rear wheel and left front wheel.

Some models don't have a bleeder fitting on the left rear brake. Both rear brakes must be bled from the right rear.

  1. Check the master cylinder fluid level. If necessary, add fluid to bring the level up.
  3. Remove the bleeder cap at the wheel cylinder or caliper. Connect a rubber hose to the bleeder and immerse the other end in a glass container half filled with brake fluid.
  5. Have an assistant depress the brake pedal to the floor, and then pause until the fluid flow stops and the bleeder nipple is closed.
  7. Allow the pedal to return and repeat the procedure until a steady, bubble-free flow is seen.
  9. Tighten the bleeder valve and replace the cap. Move on to the next wheel in sequence.

Frequently check the master cylinder level during this procedure. If the reservoir goes dry, air will enter the system and it will have to be rebled.