Chrysler Concorde/Intrepid/LHS/New Yorker/Vision 1993-1997

Speed Control Servo Cable

Print

REMOVAL & INSTALLATION



  1. Remove the throttle cable clasp from the throttle body cam.
  2.  
  3. Remove the speed control cable from the throttle cam by sliding the clasp out of the hole used for the throttle cable.
  4.  
  5. Compress the retaining tabs on the cable and slide the cable out of the bracket.
  6.  
  7. Remove the 2 nuts retaining the bracket to the servo.
  8.  
  9. Remove the clip holding the cable to the servo.
  10.  

To install:
  1. Install the retaining clip to the cable at the servo.
  2.  
  3. Slide the cable bell housing over the servo mounting studs.
  4.  
  5. Install the 2 nuts at the cable to the servo and servo bracket. Tighten the nuts to 60 inch lbs. (7 Nm).
  6.  
  7. Slide the cable into the throttle cable bracket and engage the retaining tabs.
  8.  
  9. Rotate the throttle cam forward to the wide open position and install the speed control cable clasp.
  10.  
  11. Rotate the throttle cam forward to the wide open position and install the throttle cable clasp.
  12.  

 
label.common.footer.alt.autozoneLogo