Chrysler Concorde/Intrepid/LHS/New Yorker/Vision 1993-1997

Bumpers

Print

REMOVAL & INSTALLATION



Front

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Front bumper fascia

  1. Release the hood latch and open the hood.
  2.  
  3. Remove the wheelhouse splash shields as necessary to gain access to the bumper fascia retainers.
  4.  
  5. Remove the push-in fasteners holding the bottom of the bumper fascia to the radiator closure panel.
  6.  
  7. If equipped with a fog lamp, unplug the wire connector from the body harness.
  8.  
  9. Remove the push-in fasteners holding the bumper fascia to the front fenders.
  10.  
  11. Disengage the bumper fascia from the hooks on the bottom of the front fenders.
  12.  
  13. Separate the bumper fascia from the vehicle.
  14.  

To install:
  1. Place the bumper fascia into position on the vehicle.
  2.  
  3. Engage the bumper fascia to the hooks on the bottom of the front fenders.
  4.  
  5. Install the push-in fasteners holding the bumper fascia to the front fenders.
  6.  
  7. If equipped with a fog lamp, plug the wire connector to the body harness.
  8.  
  9. Install the push-in fasteners holding the bottom of the bumper fascia to the radiator closure panel.
  10.  
  11. Install the wheelhouse splash shields, if removed.
  12.  

Rear

See Figure 2



Click image to see an enlarged view

Fig. Fig. 2: Rear bumper fascia

  1. Release the trunk latch and open the trunk.
  2.  
  3. Remove the wheelhouse splash shields as necessary to gain access to the bumper fascia retainers.
  4.  
  5. Remove the screws holding the bumper fascia to the bottom of the quarter panel.
  6.  
  7. Remove the screws holding the trunk lid lining to the lower deck panel.
  8.  
  9. Separate the trunk lid lining from the lower deck panel.
  10.  
  11. Remove the nuts holding the bumper fascia to the rear edge of the quarter panel.
  12.  
  13. If equipped, unplug the wire connector from the body harness.
  14.  
  15. Remove the push-in fasteners holding the bumper fascia to the lower deck panel.
  16.  
  17. Separate the bumper fascia from the vehicle.
  18.  

To install:
  1. Place the bumper fascia into position on the vehicle.
  2.  
  3. Install the push-in fasteners holding the bumper fascia to the lower deck panel.
  4.  
  5. If equipped, plug the wire connector to the body harness.
  6.  
  7. Install the nuts holding the bumper fascia to the rear edge of the quarter panel.
  8.  
  9. Position the trunk lid lining to the lower deck panel and install the retaining screws.
  10.  
  11. Install the screws holding the bumper fascia to the bottom of the quarter panel.
  12.  
  13. Install the wheelhouse splash shields.
  14.  

 
label.common.footer.alt.autozoneLogo