Chrysler Concorde/Intrepid/LHS/New Yorker/Vision 1993-1997

Doors

Print

REMOVAL & INSTALLATION



See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Front door and hinge installation

  1. Open the door and, using a padded device of some kind, support it securely from underneath near the outer end.
  2.  
  3. Disengage the clips holding the wire connector and boot to the hinge pillar.
  4.  
  5. Separate the connector from the hinge pillar.
  6.  
  7. Disengage the clip holding the wire connector together on the hinge pillar side of the connector.
  8.  
  9. Separate the door harness from the instrument panel harness.
  10.  
  11. With the door properly supported, remove the bolts holding the lower hinge to the door end frame.
  12.  
  13. Steady the door on the support and remove the bolts holding the upper hinge to the door end frame.
  14.  
  15. Disengage the door check stop from the pin on the upper door hinge and separate the door from the vehicle.
  16.  

To install:
  1. Position the door on the vehicle and install the door check stop onto the pin on the upper door hinge.
  2.  
  3. Steady the door on the support and install the bolts holding the upper hinge to the door end frame.
  4.  
  5. With the door properly supported, install the bolts holding the lower hinge to the door end frame.
  6.  
  7. Check the alignment and operation of the door.
  8.  
  9. Connect the door harness from the instrument panel harness.
  10.  
  11. Align the door so that there is equal spacing to the surrounding body panels. The panels should be flush across all gaps.
  12.  

ADJUSTMENT



Align the door so that there is equal spacing to the surrounding body panels. The panels should be flush across all gaps. Loosen the hinge-to-door attaching bolts and align as necessary.

 
label.common.footer.alt.autozoneLogo