Chrysler Concorde/Intrepid/LHS/New Yorker/Vision 1993-1997

Message Center

Print

REMOVAL & INSTALLATION



Except LHS

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Message center module-except LHS

  1. Using a trim stick, remove the message module from the instrument panel.
  2.  
  3. Disconnect the wiring leading to the unit.
  4.  

To install:
  1. Replace the lamps as needed.
  2.  
  3. Attach the wiring harness to the message center.
  4.  
  5. Check the operation of the bulbs replaced. If everything is OK, snap the unit into place in the dash.
  6.  

LHS

See Figure 2



Click image to see an enlarged view

Fig. Fig. 2: Message center module-LHS

  1. Open the front door and remove the left end cover.
  2.  
  3. Remove the headlamp switch bezel and the center upper outlet bezel.
  4.  
  5. Remove the woodgrain trim bezel in the center of the instrument panel, then move the bezel out of the way.
  6.  
  7. Remove the cluster bezel screws.
  8.  
  9. Disconnect the wiring from the message center. The message center lamps may be serviced at this time if necessary.
  10.  

To install:
  1. Attach the wiring to the message unit and install into the dash.
  2.  
  3. Install the cluster bezel and woodgrain trim bezels, attach with the retaining screws.
  4.  
  5. Install the center upper outlet bezel and headlamp switch bezel.
  6.  
  7. Install the left end cover.
  8.  

 
label.common.footer.alt.autozoneLogo