Chrysler Concorde/Intrepid/LHS/New Yorker/Vision 1993-1997

Door Glass

Print

REMOVAL & INSTALLATION



Front

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Front door glass installation

  1. Remove the door trim panel and upper trim retainer channel.
  2.  
  3. Connect the power window switch or install the window crank handle and lower the window to 2 in. (0.50 mm) from the bottom of travel.
  4.  
  5. Loosen the screws holding the regulator roller channel to the glass.
  6.  
  7. Slide the roller channel rearward to allow the screw heads to pass through the key hole slots in the channel.
  8.  
  9. Separate the glass from the roller channel.
  10.  
  11. Raise the glass upward and out of the opening at the top of the door.
  12.  

To install:
  1. Lower the glass into the opening at the top of the door.
  2.  
  3. Position the glass to the roller channel.
  4.  
  5. Insert the screw heads into the key hole slots in the roller channel and slide the channel forward to the locked position.
  6.  
  7. Tighten the screws holding the regulator roller channel to the glass.
  8.  
  9. Install the door trim panel and upper trim retainer channel.
  10.  

Rear

See Figure 2



Click image to see an enlarged view

Fig. Fig. 2: Rear door glass and regulator installation

  1. Remove the door trim panel and upper trim retainer channel.
  2.  
  3. Remove the window frame applique.
  4.  
  5. Raise the door glass to gain access to the roller channel-to-glass fasteners, through the holes in the inner door panel.
  6.  
  7. Loosen the screws holding the regulator roller channel to the glass.
  8.  
  9. Slide the roller channel rearward to allow the screw heads to pass through the key hole slots in the channel.
  10.  
  11. Separate the glass from the roller channel.
  12.  
  13. Raise the glass upward and out of the opening at the top of the door.
  14.  

To install:
  1. Lower the glass into the opening at the top of the door.
  2.  
  3. Position the glass to the roller channel.
  4.  
  5. Insert the screw heads into the key hole slots in the roller channel and slide the channel forward to the locked position.
  6.  
  7. Tighten the screws holding the regulator roller channel to the glass.
  8.  
  9. Install the window frame applique.
  10.  
  11. Install the door trim panel and upper trim retainer channel.
  12.  

 
label.common.footer.alt.autozoneLogo