Chrysler Concorde/Intrepid/LHS/New Yorker/Vision 1993-1997

Door Window Regulator

Print

REMOVAL & INSTALLATION



Front and Rear

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Front door window regulator installation

  1. Remove the door trim panel.
  2.  
  3. Separate the glass from the regulator roller channel as outlined in this section.
  4.  
  5. Unplug the power window motor wire connector, if equipped.
  6.  
  7. Loosen the screw holding the regulator scissor channel to the door.
  8.  
  9. Loosen the bolt holding the regulator support brace to the door panel.
  10.  
  11. Separate the screw and bolt heads from the keyhole slots in the door panel.
  12.  
  13. Loosen the bolts holding the regulator to the door panel.
  14.  
  15. Slide the regulator rearward and rotate the forward end of the roller channel through the access hole in the door panel.
  16.  

To install:
  1. Insert the regulator through the access hole in the door panel.
  2.  
  3. Insert the bolt heads on the regulator through the keyhole slots in the door panel.
  4.  
  5. Tighten the bolts holding the regulator to the door panel.
  6.  
  7. Insert the bolt heads on the support brace and scissor channel into the key hole slot on the door panel.
  8.  
  9. Tighten the bolt holding the regulator support brace to the door panel.
  10.  
  11. Tighten the screw holding the regulator scissor channel to the door.
  12.  
  13. Engage the power window motor wire connector, if equipped.
  14.  
  15. Install the glass to the regulator roller channel as outlined in this section.
  16.  
  17. Verify operation of the window.
  18.  
  19. Install the door trim panel.
  20.  

 
label.common.footer.alt.autozoneLogo