Chrysler Concorde/Intrepid/LHS/New Yorker/Vision 1993-1997

Power Seat Motor

Print

REMOVAL & INSTALLATION



  1. Move the seat adjuster as required for easy access to the mounting bolts, if possible. Remove the adjuster mounting bolts/nuts from the floor pan.
  2.  
  3. Disconnect the battery negative cable. Detach the wiring harness motor connector at the carpet. Then, remove the seat from the car as described earlier in this section.
  4.  
  5. Lay the seat on its back on a clean surface. Then, remove the motor mounting screws from the motor bracket and the single mounting bolt from the adjuster.
  6.  
  7. Note the routing of the cable to the motor. Then, carefully disconnect the housing and cables from the motor assembly. Remove the motor from the seat bottom.
  8.  

To install:
  1. To install the motor, first position it in its mounted position.
  2.  
  3. Connect the cables and the housing to the motor.
  4.  
  5. Install the motor mounting screws. Install the bolt fastening the motor to the adjuster.
  6.  
  7. Install the seat as described earlier in this section.
  8.  
  9. Attach the wiring harness connector and the battery negative cable. Check the seat for proper operation.
  10.  

 
label.common.footer.alt.autozoneLogo