Chrysler Front Wheel Drive Cars 4-CYL 1981-1995 Repair Information

General Precautions


Be sure to consult the laws in your area before servicing the air conditioning system. In most areas, it is illegal to perform repairs involving refrigerant unless the work is done by a certified technician. Also, it is quite likely that you will not be able to purchase refrigerant without proof of certification.


There are two major hazards associated with air conditioning systems and they both relate to the refrigerant gas. First, the refrigerant gas (R-12 or R-134a) is an extremely cold substance. When exposed to air, it will instantly freeze any surface it comes in contact with, including your eyes. The other hazard relates to fire (if your vehicle is equipped with R-12. Although normally non-toxic, the R-12 gas becomes highly poisonous in the presence of an open flame. One good whiff of the vapor formed by burning R-12 can be fatal. Keep all forms of fire (including cigarettes) well clear of the air conditioning system.

Because of the inherent dangers involved with working on air conditioning systems, these safety precautions must be strictly followed.

Avoid contact with a charged refrigeration system, even when working on another part of the air conditioning system or vehicle. If a heavy tool comes into contact with a section of tubing or a heat exchanger, it can easily cause the relatively soft material to rupture.
When it is necessary to apply force to a fitting which contains refrigerant, as when checking that all system couplings are securely tightened, use a wrench on both parts of the fitting involved, if possible. This will avoid putting torque on refrigerant tubing. (It is also advisable to use tube or line wrenches when tightening these flare nut fittings.)

R-12 refrigerant is a chlorofluorocarbon which, when released into the atmosphere, can contribute to the depletion of the ozone layer in the upper atmosphere. Ozone filters out harmful radiation from the sun.

Do not attempt to discharge the system without the proper tools. Precise control is possible only when using the service gauges and a proper A/C refrigerant recovery station. Wear protective gloves when connecting or detaching service gauge hoses.
Discharge the system only in a well ventilated area, as high concentrations of the gas which might accidentally escape can exclude oxygen and act as an anesthetic. When leak testing or soldering, this is particularly important, as toxic gas is formed when R-12 contacts any flame.
Never start a system without first verifying that both service valves are properly installed, and that all fittings throughout the system are snugly connected.
Avoid applying heat to any refrigerant line or storage vessel. Charging may be aided by using water heated to less than 125°F (50°C) to warm the refrigerant container. Never allow a refrigerant storage container to sit out in the sun, or near any other source of heat, such as a radiator or heater.
Always wear goggles to protect your eyes when working on a system. If refrigerant contacts the eyes, it is advisable in all cases to consult a physician immediately.
Frostbite from liquid refrigerant should be treated by first gradually warming the area with cool water, and then gently applying petroleum jelly. A physician should be consulted.
Always keep refrigerant drum fittings capped when not in use. If the container is equipped with a safety cap to protect the valve, make sure the cap is in place when the can is not being used. Avoid sudden shock to the drum, which might occur from dropping it, or from banging a heavy tool against it. Never carry a drum in the passenger compartment of a vehicle.
Always have the system completely discharged into a suitable recovery unit before painting the vehicle (if the paint is to be baked on), or before welding anywhere near refrigerant lines.
When servicing the system, minimize the time that any refrigerant line or fitting is open to the air in order to prevent moisture or dirt from entering the system. Contaminants such as moisture or dirt can damage internal system components. Always replace O-rings on lines or fittings which are detached. Prior to installation coat, but do not soak, replacement O-rings with suitable compressor oil.