Chrysler Front Wheel Drive Cars 4-CYL 1981-1995 Repair Information

Combination Control Valve

Print

REMOVAL & INSTALLATION



  1. Unfasten the electrical connector from the valve.
  2.  
  3. Place a drain pan under the valve. Disconnect all six hydraulic line flare nuts.
  4.  
  5. Remove the mounting bolt and remove the valve from the fender well.
  6.  

To install:
  1. Bolt the new valve onto the fender well.
  2.  
  3. Reconnect all six flare nut fittings. Tighten the flare nuts to 145 inch lbs. (16 Nm).
  4.  
  5. Reattach the electrical connector.
  6.  
  7. Thoroughly bleed the brake system as described later in this section. Then, repeatedly stop the vehicle with firm application on the pedal to center the warning switch spool valve and extinguish the brake light.
  8.  

 
label.common.footer.alt.autozoneLogo