Chrysler Front Wheel Drive Cars 4-CYL 1981-1995 Repair Information

Blower Switch

Print

REMOVAL & INSTALLATION



This procedure applies to all vehicles covered by this information; however slight variances may occur and this procedure should be adjusted accordingly.

  1. Disconnect the negative battery cable, then remove the heater control panel from the vehicle's dashboard.
  2.  

To protect the cosmetic face plate, place cardboard or a similar material on the face plate while prying.

  1. Pry the temperature and blower switch knobs off with a flat blade prytool.
  2.  
  3. Remove the face plate by lifting on the 6 tabs, 3 of which are on the top and 3 on the bottom of the face plate.
  4.  

To protect the cosmetic face plate, place cardboard or a similar material on the face plate while prying.

  1. Pry the blower switch off of the heater-A/C control panel with a flat blade prytool.
  2.  

To install:
  1. Line up the blower switch terminals with the holes in the control panel and press firmly until it bottoms out on the housing.
  2.  
  3. Install the face plate onto the control panel and press until all of the tabs engage the panel.
  4.  
  5. Push the temperature and blower switch knobs back onto their respective levers.
  6.  
  7. Install the heater control panel as described in the previous procedure. Attach the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo