Chrysler Front Wheel Drive Cars 4-CYL 1981-1995 Repair Information

Seat Belt Systems

Print

REMOVAL & INSTALLATION



Front
OUTBOARD SHOULDER

See Figure 1

Click image to see an enlarged view

Fig. Fig. 1: The common front seat belt system components

  1. Remove the necessary trim panel(s).
  2.  
  3. Remove the bolt holding seat belt retractor to B-pillar.
  4.  
  5. Separate retractor from the vehicle.
  6.  

To install:
  1. Install the retractor into the vehicle.
  2.  
  3. Install the seat belt retractor-to-B-pillar attaching bolt and tighten to 30-40 ft. lbs. (40-54 Nm).
  4.  
  5. Install the trim panels which were removed.
  6.  

INBOARD BUCKLE
  1. Remove the bolt holding the inboard buckle/center occupant belt to the floor.
  2.  
  3. Unplug the belt sensor wire connector.
  4.  
  5. Remove the inboard buckle/center occupant belt from the vehicle.
  6.  
  7. Installation is the reverse of removal. Tighten the attaching bolts to 30-40 ft. lbs. (40-54 Nm).
  8.  

Rear

See Figure 2

Click image to see an enlarged view

Fig. Fig. 2: The common rear seat belt system components

  1. Remove the necessary trim panel(s).
  2.  
  3. Remove the bolt holding lap belt to floor at wheelhouse kickup.
  4.  
  5. Remove the bolt holding seat belt retractor to quarter panel.
  6.  

To install:
  1. Install the bolt to hold the seat belt retractor to the quarter panel. Tighten the seat belt retaining bolts to 30-40 ft. lbs. (40-54 Nm).
  2.  
  3. Install the bolt holding the lap belt to the floor at the wheelhouse kickup.
  4.  
  5. Install the necessary trim panel(s).
  6.  

 
label.common.footer.alt.autozoneLogo