Chrysler Front Wheel Drive Cars 6-CYL 1988-1995 Repair Information

Control Cables

Print

This procedure is for vehicles with separate heater and A/C control panels. For vehicles with combined heater-A/C control panels, refer to the procedures found earlier in this section.

REMOVAL & INSTALLATION

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the necessary bezel(s) in order to gain access to the control panel.
  4.  
  5. Remove the screws that fasten the control panel to the instrument panel.
  6.  
  7. Pull the unit out and disconnect the temperature control cable by pushing the flag in and pulling the end from its seat.
  8.  
  9. The temperature control cable end is located at the bottom of the heater/air conditioning housing. Disconnect the cable end by pushing the flag in and pulling the end from its seat.
  10.  
  11. Disconnect the self-adjusting clip from the blend air or mode door crank.
  12.  
  13. Take note of the cable's routing and remove it from the vehicle.
  14.  

To install:
  1. Install the cable by routing it in exactly the same position as it was prior to removal.
  2.  
  3. Connect the self-adjusting clip to the door crank and click the flag into the seat.
  4.  
  5. Connect the upper end of the cable to the control panel.
  6.  
  7. Place the temperature lever on the coolest side of its travel. Allowing the self-adjusting clip to slide on the cable, rotate the blend air door counterclockwise by hand until it stops.
  8.  
  9. Cycle the lever back and forth a few times to make sure the cable moves freely.
  10.  
  11. Install the control panel attaching screws, then install any bezels removed earlier.
  12.  
  13. Connect the negative battery cable and check the entire climate control system for proper operation.
  14.  

 
label.common.footer.alt.autozoneLogo