Chrysler Front Wheel Drive Cars 6-CYL 1988-1995 Repair Information

Outside Mirrors

Print

REMOVAL & INSTALLATION



Except Premier and Monaco

See Figure 1

  1. Remove the front door trim panel.
  2.  
  3. Remove the side view mirror remote adjusting knob cover, if equipped.
  4.  
  5. Remove the screws holding the mirror bezel to the door frame. Separate the bezel from the door. Loosen the setscrew holding the bezel to the mirror adjuster cable, if equipped.
  6.  
  7. Remove the silencer seal from the door frame behind the mirror bezel.
  8.  
  9. Unplug the power mirror wire connector, if equipped.
  10.  
  11. Remove the access hole cover.
  12.  
  13. Remove the nuts holding the mirror to the door frame, then separate the mirror from the door.
  14.  



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of the mounting of the exterior side view mirror

To install:
  1. Position the mirror against the door frame, then install the retaining nuts. Tighten the nuts until snug.
  2.  
  3. Install the access hole cover.
  4.  
  5. Attach the wire connector to the mirror, if applicable.
  6.  
  7. Install the silencer seal to the door frame.
  8.  
  9. Install the bezel over the mirror adjuster cable (if equipped) and install the bezel to the door frame. Tighten the bezel setscrew to hold the mirror adjuster cable in position.
  10.  
  11. Install the side view mirror remote adjusting knob cover, if equipped.
  12.  
  13. Install the door trim panel.
  14.  

Premier and Monaco

See Figures 2 and 3

  1. Remove the mirror bezel from the inside surface of the mirror.
  2.  
  3. Remove the screws holding the retainer to the door. Remove the retainer.
  4.  
  5. Remove the nuts holding the mirror to the door. Separate the mirror from the door.
  6.  



Click image to see an enlarged view

Fig. Fig. 2: Remove the mirror bezel by pushing in the direction shown



Click image to see an enlarged view

Fig. Fig. 3: Remove the retainer unit to gain access to the mirror retaining nuts

To install:
  1. Position the mirror against the outside of the door, then install the retaining nuts until tight.
  2.  
  3. Install the retainer and secure in place with the retainer mounting screws.
  4.  
  5. Install the bezel to the inside of the mirror.
  6.  

 
label.common.footer.alt.autozoneLogo