Chrysler Front Wheel Drive Cars 6-CYL 1988-1995 Repair Information

Windshield Wiper Switch

Print

REMOVAL & INSTALLATION



Except Premier, Monaco, Daytona and LeBaron

The front wiper switch on most vehicles (exceptions below) is part of the combination turn signal/cruise control/wiper switch or column mounted assembly. Refer to the appropriate procedure in Suspension & Steering or the service procedures below.

Daytona and LeBaron Coupe/Convertible
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the panel vent grille above the switch pod assembly and remove the 2 revealed pod mounting screws.
  4.  
  5. Remove the 2 remaining screws under the pod and pull the pod out to disconnect the wiring harnesses. Remove the pod from the instrument panel.
  6.  
  7. Remove the inner panel from the pod. Disconnect the switch linkage from the buttons.
  8.  
  9. Remove the windshield wiper switch mounting screws and remove the entire switch assembly.
  10.  

To install:
  1. Install the wiper switch and mount with the retaining screws.
  2.  
  3. Connect the linkage to the buttons and install the inner panel into the pod.
  4.  
  5. Install the pod into the instrument panel. Connect the wiring harness.
  6.  
  7. Install the panel vent grille.
  8.  
  9. Connect the negative battery cable and check the entire wiper system for proper operation.
  10.  

Premier and Monaco

Refer to the Headlight (Combination Switch) service procedures in this section.

 
label.common.footer.alt.autozoneLogo