Chrysler Front Wheel Drive Cars 6-CYL 1988-1995 Repair Information

Headliner

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Pull dome lamp downward to disengage from the retaining ring in headliner. Separate lens from lamp body and remove the bulb. Separate bulb holder from the lamp body. Remove the attaching screw holding retaining ring to roof bow.
  4.  
  5. Remove the screws holding coat hooks to roof above rear doors.
  6.  
  7. Remove roof rail and A-pillar mouldings.
  8.  
  9. Remove screws holding sun visors to roof header and detach the wire connector, if so equipped. Remove the inboard sun visor hangers.
  10.  
  11. Remove the overhead console assembly, if so equipped.
  12.  
  13. Pull the front reading lamp downward to disengage it from the retaining ring in the headliner and detach the electrical connector. Remove the screws holding the retaining ring to the roof header.
  14.  
  15. Remove the pinch welt holding the headliner to the sun roof opening, if so equipped.
  16.  
  17. Remove the inside rear view mirror from the windshield bracket, if applicable.
  18.  
  19. Disengage the hook and loop fasteners holding the headliner to the roof above the rear window and slide the headliner forward about 1 in. (25mm).
  20.  
  21. Shift the front of the headliner to one side to pull the headliner from behind the B-pillar trim. Pull the headliner from behind the other B-pillar trim.
  22.  
  23. Allow the front of the headliner to drop downward. Slide the headliner forward from behind the quarter panel trim. Remove the headliner from the vehicle.
  24.  



Click image to see an enlarged view

Fig. Fig. 1: The headliner has the same basic set up for all vehicles covered by this vehicle

To install:
  1. Install the headliner in the proper position, and engage the necessary fasteners and panel trim components.
  2.  
  3. Install the rear view mirror to the windshield.
  4.  
  5. Install the front reading lamp assembly, if so equipped.
  6.  
  7. Install the overhead console, if so equipped.
  8.  
  9. Install the sun visors.
  10.  
  11. Install the A-pillar mouldings and roof rail.
  12.  
  13. Install the coat hooks to the roof above the rear doors.
  14.  
  15. Install the dome light assembly. Check all necessary items for proper operation.
  16.  
  17. Connect the negative battery cable.
  18.  

 
label.common.footer.alt.autozoneLogo