See Figure 1
For maximum effectiveness and longest element life, the windshield and wiper blades should be kept clean. Dirt, tree sap, road tar and so on will cause streaking, smearing and blade deterioration if left on the glass. It is advisable to wash the windshield carefully with a commercial glass cleaner at least once a month. Wipe off the rubber blades with the wet rag afterwards. Do not attempt to move the wipers by hand; damage to the motor and drive mechanism will result.
If the blades are found to be cracked, broken or torn, they should be replaced immediately. Replacement intervals will vary with usage, although ozone deterioration usually limits blade life to about one year. If the wiper pattern is smeared or streaked, or if the blade chatters across the glass, the elements should be replaced. It is easiest and most sensible to replace the elements in pairs.
WIPER REFILL REPLACEMENT
There are basically three different types of refills, which differ in their method of replacement. One type has two release buttons, approximately 1 / 3 of the way up from the ends of the blade frame. Pushing the buttons down releases a lock and allows the rubber filler to be removed from the frame. The new filler slides back into the frame and locks in place.
The second type of refill has two metal tabs which are unlocked by squeezing them together. The rubber filler can then be withdrawn from the frame jaws. A new refill is installed by inserting the refill into the front frame jaws and sliding it rearward to engage the remaining frame jaws. There are usually four jaws. Be certain when installing that the refill is engaged in all of them. At the end of its travel, the tabs will lock into place on the front jaws of the wiper blade frame.
The third type is a refill made from polycarbonate. The refill has a simple locking device at one end which flexes downward out of the groove into which the jaws of the holder fit, allowing easy release. By sliding the new refill through all the jaws and pushing through the slight resistance when it reaches the end of its travel, the refill will lock into position.
Regardless of the type of refill used, make sure that all of the frame jaws are engaged as the refill is pushed into place and locked. The metal blade holder and frame will scratch the glass if allowed to touch it.
WIPER ARM REMOVAL AND REPLACEMENT
A detailed description and procedures for replacing the wiper arm and blade is found in Chassis Electrical .