Chrysler Front Wheel Drive Cars 6-CYL 1988-1995 Repair Information

Windshield Washer Motor

Print

REMOVAL & INSTALLATION



  1. Drain the washer fluid from the reservoir.
  2.  
  3. Remove the mounting screws from the reservoir and remove the reservoir/pump assembly from the vehicle.
  4.  
  5. Disconnect the electrical lead and rubber hose from the bottom of the pump.
  6.  
  7. Gently pry the pump away from the reservoir and out of the grommet. Care must be taken not to puncture the reservoir.
  8.  
  9. Remove the rubber grommet from the reservoir and discard.
  10.  

To install:
  1. Install a new rubber grommet on the reservoir.
  2.  
  3. Position the pump into place and push in firmly until it locks into the grommet.
  4.  
  5. Connect the electrical lead and rubber hose to the pump.
  6.  
  7. Position the reservoir into place and install the mounting screws until snug.
  8.  
  9. Fill the reservoir with washer fluid.
  10.  

 
label.common.footer.alt.autozoneLogo