Chrysler Full-Size Trucks 1967-1988 Repair Guide

Condenser

Print

REMOVAL & INSTALLATION



  1. Using an approved R-12 recovery/recycling station, follow the manufacturer's instructions to discharge the refrigerant system. See General Information & Maintenance .
  2.  
  3. Disconnect the refrigerant lines from the condenser. Cap all openings immediately!
  4.  
  5. Drain the cooling system.
  6.  


CAUTION
When draining the coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze, and are quite likely to drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantity. Always drain the coolant into a sealable container. Coolant should be reused unless it is contaminated or several years old.

  1. Disconnect the upper radiator hose.
  2.  
  3. Remove the bolts retaining the ends of the radiator upper support to the side supports.
  4.  
  5. Carefully pull the top edge of the radiator rearward and remove the condenser upper support.
  6.  
  7. Lift out the condenser.
  8.  
  9. Installation is the reverse of removal. If a new condenser is being installed, add 1 fl. oz. of new refrigerant oil to the new condenser. Always use new O-rings coated with clean refrigerant oil on the line fittings. Use an approved R-12 recovery/recycling station, and follow the manufacturer's instructions to evacuate, charge and leak test the system.
  10.  

 
label.common.footer.alt.autozoneLogo