Chrysler Full-Size Trucks 1967-1988 Repair Guide

Power Door Locks

Print

REMOVAL & INSTALLATION



Actuator Motor

See Figure 1

  1. Raise the glass to the full UP position.
  2.  
  3. Remove the door handle, window regulator handle, if so equipped, and door trim panel.
  4.  
  5. Roll the door watershield away from the lower rear corner of the door to reveal the inside panel access opening.
  6.  
  7. Disconnect the motor from the door latch.
  8.  
  9. Remove the motor and swivel bracket from the door by drilling out the pop rivet.
  10.  



Click image to see an enlarged view

Fig. Fig. 1: Power door lock motor assembly

  1. Disconnect the wiring harness.
  2.  

To install:
  1. Attach the mounting bracket to the door inside panel and screws.
  2.  
  3. Attach the link to the motor rod and connect the wires.
  4.  
  5. Reset the watershield at the lower rear corner of the door.
  6.  
  7. Install the window regulator handle, if so equipped, as well as the door inside release lever handle and door trim panel.
  8.  

 
label.common.footer.alt.autozoneLogo