Chrysler Full-Size Trucks 1997-2000 Repair Guide

Throttle Position Sensor (TPS)

Print

OPERATION



The Throttle Position sensor (TPS) is a potentiometer that provides a voltage signal to the PCM that is directly proportional to the throttle plate position. The sensor is mounted on the side of the throttle body and is connected to the throttle plate shaft. The TPS monitors throttle plate movement and position, and transmits an appropriate electrical signal to the PCM. These signals are used by the PCM to adjust the air/fuel mixture, spark timing and EGR operation according to engine load at idle, part throttle, or full throttle. The TPS is not adjustable.

The TPS receives a 5-volt reference signal and a ground circuit from the PCM. A return signal circuit is connected to a wiper that runs on a resistor internally on the sensor. The further the throttle is opened, the wiper moves along the resistor, at wide open throttle, the wiper essentially creates a loop between the reference signal and the signal return returning the full or nearly full 5 volt signal back to the PCM. At idle the signal return should be approximately 0.9 volts.



Click image to see an enlarged view

Fig. TPS location on the throttle body-typical

TESTING



  1. With the engine OFF and the ignition ON , check the voltage at the signal return circuit of the TP sensor by carefully backprobing the connector using a DVOM.
  2.  
  3. Voltage should be between 0.2 and 1.4 volts at idle.
  4.  
  5. Slowly move the throttle pulley to the wide open throttle (WOT) position and watch the voltage on the DVOM. The voltage should slowly rise to slightly less than 4.5v at Wide Open Throttle (WOT).
  6.  
  7. If no voltage is present, check the wiring harness for supply voltage (5.0v) and ground (0.3v or less), by referring to your corresponding wiring guide. If supply voltage and ground are present, but no output voltage from TPS, replace the TPS. If supply voltage and ground Do NOT meet specifications, make necessary repairs to the harness or PCM.
  8.  



Click image to see an enlarged view

Fig. Identifying Throttle Position Sensor electrical connector terminals



Click image to see an enlarged view

Fig. Throttle Position Sensor circuit schematic



Click image to see an enlarged view

Fig. Using a voltmeter to check the TPS for signal voltage



Click image to see an enlarged view

Fig. Using a voltmeter to check the TPS for reference (supply) voltage



Click image to see an enlarged view

Fig. You can use the data display function of the Auto Xray®, or other scan tool, to get the TPS readings

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the air cleaner assembly.
  4.  
  5. Unplug the TPS connector.
  6.  
  7. Remove the two retaining bolts.
  8.  
  9. Remove the sensor from the throttle body.
  10.  

To install:

  1. Install the sensor on the throttle body.
  2.  
  3. Tighten the sensor bolts to 60 inch lbs. (7 Nm)
  4.  
  5. Open the throttle to WOT and back again several times to check for binding.
  6.  
  7. Plug in the connector.
  8.  
  9. Install the air cleaner assembly.
  10.  
  11. Connect the negative battery cable.
  12.  



Click image to see an enlarged view

Fig. TPS mounting-typical



Click image to see an enlarged view

Fig. Align the locating tangs on the TPS with the throttle shaft

 
label.common.footer.alt.autozoneLogo