Chrysler Full-Size Trucks 1997-2000 Repair Guide

Ignition Timing (Gasoline Engines)



Ignition timing is the measurement, in degrees of crankshaft rotation, of the point at which the spark plugs fire in each of the cylinders. It is measured in degrees before or after Top Dead Center (TDC) of the compression stroke.

Ideally, the air/fuel mixture in the cylinder will be ignited by the spark plug just as the piston passes TDC of the compression stroke. If this happens, the piston will be beginning the power stroke just as the compressed and ignited air/fuel mixture starts to expand. The expansion of the air/fuel mixture then forces the piston down on the power stroke and turns the crankshaft.

Because it takes a fraction of a second for the spark plug to ignite the mixture in the cylinder, the spark plug must fire a little before the piston reaches TDC. Otherwise, the mixture will not be completely ignited as the piston passes TDC, and the engine will not use the full power of the explosion.

As the engine speed increases, the pistons go faster. The spark plugs therefore have to ignite the fuel even sooner if it is to be completely ignited when the piston reaches TDC.

The Powertrain Control Module (PCM) receives inputs from Crankshaft Position (CKP) sensors and Camshaft Position (CMP) sensors along with various other sensors to control spark timing. Refer "Engine Electrical" for more information.

Click image to see an enlarged view

Fig. The notches on the reluctor wheel trigger the Crankshaft Position (CKP) sensor to signal the Powertrain Control Module (PCM) on crankshaft position and speed-5.2L and 5.9L gasoline engines shown

Click image to see an enlarged view

Fig. The reluctor wheel is located on the crankshaft-8.0L engine shown

Click image to see an enlarged view

Fig. The Camshaft Position (CMP) sensor is used along with the CKP sensor to determine spark timing and fuel injection synchronization-8.0L engine shown

Click image to see an enlarged view

Fig. On some engines, the CMP is located within the distributor assembly-3.9L and 5.2L engines shown

Click image to see an enlarged view

Fig. Distributorless ignition systems fire two plugs at the same time. Refer to "Engine Electrical" for more information-8.0L engine


Base ignition timing is not adjustable on any engine covered in this guide. The distributors do NOT have centrifugal or vacuum advance. Instead, base ignition timing and its Powertrain Control Module (PCM) controls advance on each of these engines.