Chrysler Full-Size Vans 1967-1988 Repair Guide

Wiper Linkage

Print

REMOVAL & INSTALLATION



1967-69 Models

LEFT LINK
  1. Remove the motor and linkage as described above.
  2.  
  3. Remove the left link-to-crank arm retainer.
  4.  
  5. Installation is the reverse of removal.
  6.  

RIGHT LINK
  1. Remove the motor and linkage as described above.
  2.  
  3. Remove the link retaining nut from the crank arm.
  4.  
  5. Installation is the reverse of removal.
  6.  

1970-72 Models

  1. Remove the cowl grille.
  2.  
  3. Disconnect the washer hoses.
  4.  
  5. Release the linkage-to-motor clip.
  6.  
  7. Remove the 2 mount bolts on each pivot.
  8.  
  9. Push the pivots into the plenum chamber and remove the pivots and linkage through the cowl grille opening.
  10.  

1973 Models

DRIVE LINK
  1. Remove the cowl grille.
  2.  
  3. Remove the retainer, metal washer and rubber washer attaching the drive link to the connecting link.
  4.  
  5. Remove the retainer and wave washer attaching the drive link to the wiper motor arm.
  6.  
  7. Remove the drive link from the plenum chamber.
  8.  
  9. Installation is the reverse of removal.
  10.  

CONNECTING LINK
  1. Remove the cowl grille.
  2.  
  3. Remove the retainer, metal washer and rubber washer attaching the connecting link to the drive link.
  4.  
  5. Remove the retainers, metal washers and rubber washers attaching the connecting link to the pivots.
  6.  
  7. Remove the connecting link from the plenum chamber.
  8.  
  9. Installation is the reverse of removal.
  10.  

1974-88 Models

DRIVE LINK
  1. Remove the wiper arms and washer hoses.
  2.  
  3. Remove the cowl grille.
  4.  
  5. Reach through the access hole, remove the drive link from the crank arm and connecting links by prying the retainer bushings apart with a screwdriver.
  6.  
  7. Remove the drive link through the access hole.
  8.  

CONNECTING LINK
  1. Remove the cowl grille.
  2.  
  3. Reach through the access hole, remove the connecting link from the drive link by prying the retainer bushings apart with a screwdriver.
  4.  
  5. Remove the connecting link through the access hole.
  6.  

 
label.common.footer.alt.autozoneLogo