REMOVAL & INSTALLATION
See Figures 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11 and 12
- Raise and safely support the vehicle securely on jackstands.
- Remove the wheels.
- Remove the caliper assembly and support it using a piece of mechanic's wire attached to the frame.
Do not disconnect the brake fluid hose or allow the caliper to hang by the hose.
- Remove the grease cap from the hub.
- Remove the cotter pin, nut lock, adjusting nut and flat washer from the spindle.
- Tilt the rotor slightly to remove the outer bearing assembly from the hub.
- Pull the rotor assembly off the wheel spindle.
- Remove and discard the old grease seal at the rear of the rotor.
- Remove the inner bearing cone and roller assembly from the hub.
- Clean all grease from the inner and outer bearing cups with solvent. Inspect the bearing races for pits, scratches, or excessive wear. If the races are damaged, remove them with a drift.
- Clean the inner and outer cone and roller assemblies with solvent and dry them. If the cone and roller assemblies show excessive wear or damage, replace them as an assembly with new bearing races.
Do not dry the bearings with compressed air. Spinning the bearing without lubrication may cause damage.
- Clean the spindle and the inside of the hub with solvent to thoroughly remove all old grease.
- If the inner and/or outer bearing cups were removed, install the replacement cups on the hub. Be sure that the cups seat properly in the hub.
- It is imperative that all old grease be removed from the bearings and surrounding surfaces before repacking. The new EP High Temperature Grease is not compatible with the sodium base grease used in the past.
- Use a bearing packer, if available, to pack the new bearings with grease. If not, work the grease in between the rollers and the outer and inner races of the bearing, using the palm of your hand. Work from the larger diameter of the bearing. Make sure the grease goes through the width of the bearing to the small diameter. Pack and install the inner bearing first.
- Install the inner bearing grease seal with an appropriate driver.
- Install the hub and disc on the wheel spindle. To prevent damage to the grease retainer and spindle threads, keep the hub centered on the spindle.
- Install the outer bearing cone and roller assembly and the flat washer on the spindle. Install the adjusting nut.
- Adjust the wheel bearings. Rotate the wheel, hub and rotor assembly while tightening the adjusting nut to 240-60 inch lbs. (3-10 Nm) in order to seat the bearings. Back off the adjusting nut 1 / 4 turn (90°), then finger-tighten the adjusting nut.
- Locate the nut lock on the adjusting nut so that the castellations on the lock are lined up with the cotter pin hole in the spindle. Install the new cotter pin, bending the ends of the cotter pin around the castellated flange of the nut lock.
Bend the ends of the cotter pin around the castellations of the locknut to prevent interference.
- Check the wheel for proper rotation, then install the grease cap.
- Install the wheels.
Failure to tighten the lug nuts to the proper torque in a star pattern may result in damage to the brake rotor.
- Lower the vehicle