Chrysler Full-Size Vans 1989-1998 Repair Guide

Headlight Switch

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the knee bolster panel (not necessary on 1998 models).
  4.  
  5. Working under the instrument panel, depress the locking button on the switch and pull the knob and stem from the switch (not necessary on 1998 models).
  6.  
  7. Remove the instrument cluster bezel.
  8.  
  9. Remove the switch bezel mounting screws.
  10.  
  11. Remove the switch mounting nut, remove the switch and disconnect the wiring.
  12.  

To install:
  1. Place the light switch into position after connect the wiring harness.
  2.  
  3. Secure the switch with the mounting nut.
  4.  
  5. Install the switch bezel and secure it with the mounting screws.
  6.  
  7. Install the instrument cluster bezel.
  8.  
  9. Push the headlamp switch knob and stem into the switch until it is locked into position.
  10.  
  11. Install the knee bolster panel (if necessary).
  12.  
  13. Connect the negative battery cable.
  14.  



Click image to see an enlarged view

Fig. Fig. 1: The headlamp switch is located at the upper left side of the instrument panel (cluster trim bezel removed)

 
label.common.footer.alt.autozoneLogo