REMOVAL & INSTALLATION
See Figures 1, 2, 3, 4, 5 and 6
Fig. Fig. 1: The engine cover is fastened at several locations (arrows)
Fig. Fig. 2: To remove the engine cover, first unfasten the overcenter clips at the firewall
Fig. Fig. 3: Next, pull back the rug and remove the clips attaching the cover to the floor with either a screwdriver ...
Fig. Fig. 4: ... or a wrench
Fig. Fig. 5: Remove the clip from the cover ...
Fig. Fig. 6: ... and lift the cover from the passenger compartment
The inside engine cover is attached to the floor with retaining clips and with screws at the rear; it also latches to the firewall.
Remove the rear retaining screws.
Unfasten the latches at the front.
Remove the cover.
Place the cover in position.
Install the rear screws finger-tight.
Fasten the front latches, then tighten the mounting screws to 3 inch lbs. (3 Nm).