Chrysler Full-Size Vans 1989-1998 Repair Guide

Fault Codes


If a system fault is detected during the self-test, or at any other time, the control module will illuminate the Anti-Lock indicator lamp and store the fault code in the microprocessor memory. If a fault code is generated, the module will remember the code after the ignition is switched OFF . The microprocessor memory will store and display only one fault code at a time. The stored code can be displayed by grounding the RWAL diagnostic connector and counting the number of flashes on the indicator lamp. To clear the fault code, disconnect the control module connector or disconnect the battery for at least 5 seconds. During system retest, wait 30 seconds to make sure the fault code does not reappear.

See Figure 1

Click image to see an enlarged view

Fig. Fig. 1 Codes