Chrysler Neon 1995-1999 Repair Guide

Engine Fan

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Detach the fan motor leads from the module.
  4.  
  5. Unfasten the fan module fasteners from the radiator, then remove the module from the vehicle.
  6.  



Click image to see an enlarged view

Fig. Fig. 1: Location of the fan module assembly upper and lower mounts

To install:
  1. Position the fan module to the radiator. Install the shroud-to-radiator fasteners and tighten to 65 inch lbs. (7.5 Nm).
  2.  
  3. Attach the fan motor lead.
  4.  
  5. Connect the negative battery cable.
  6.  

TESTING



  1. Detach the fan motor electrical connector.
  2.  
  3. Connect the fan wire with #14 gauge wire to a known-good 12-volt battery, observing good polarity.
  4.  
  5. If the fan runs normally, the motor is functioning properly.
  6.  
  7. If not, replace the fan module using the procedure located earlier in this section.
  8.  

 
label.common.footer.alt.autozoneLogo