Chrysler Neon 1995-1999 Repair Guide

Blower Motor

Print

REMOVAL & INSTALLATION



With Air Conditioning

See Figures 1 and 2

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the right side scuff plate.
  4.  
  5. Pull back the carpet from the passenger's side floor.
  6.  


WARNING
Be careful not to cut into the blower motor wiring!

  1. Use a suitable utility knife to cut the wheel housing silencer in line with the blower motor wiring.
  2.  
  3. Detach the blower motor electrical connector.
  4.  
  5. For right-hand drive vehicles, remove the motor cover.
  6.  
  7. Unfasten the three blower motor retaining screws, then lower the blower motor assembly from the unit housing.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: The blower motor assembly is located under the passenger's side dash panel



Click image to see an enlarged view

Fig. Fig. 2: Blower motor mounting and location of the retaining screws and wiring-vehicles with A/C

To install:
  1. Raise the blower motor into position in the unit housing and secure with the three retaining screws.
  2.  
  3. If removed, install the motor cover.
  4.  
  5. Attach the blower motor electrical connector.
  6.  
  7. Use tape to secure the silencer into position.
  8.  
  9. Reposition the passenger's side floor carpeting.
  10.  
  11. Install the right side scuff plate.
  12.  
  13. Connect the negative battery cable.
  14.  

Without Air Conditioning

See Figure 3

  1. Disconnect the negative battery cable.
  2.  
  3. Detach the blower motor electrical connector.
  4.  
  5. Grasp the blower motor, while pulling down on the tab. Turn the motor about 1 / 8 of a turn counterclockwise, then remove the blower motor from the unit housing.
  6.  



Click image to see an enlarged view

Fig. Fig. 3: On vehicles without A/C, turn the motor assembly 1/8 of a turn to unlock it from the unit

To install:
  1. Position the blower motor in the unit housing and turn the assembly 1 / 8 of a turn to lock in place.
  2.  
  3. Attach the blower motor electrical connector.
  4.  
  5. Connect the negative battery cable.
  6.  

 
label.common.footer.alt.autozoneLogo