Chrysler RAM50/D50/Arrow 1979-1993 Repair Guide




1983-86 Models

See Figure 1

On these vehicles, the clock is mounted behind the instrument cluster. Refer to the instructions regarding the removal and installation of the combination meter/instrument cluster and remove the cluster from the vehicle. Remove the clock from the back of the instrument cluster.

To install the clock, simply attach the clock to the back of the instrument cluster and connect the wires. Install the instrument cluster in the instrument panel.

1987-93 Models

For these models, the clock is simply an assembly which is plugged into the dashboard. To remove the clock, use a plastic trim tool and pry the clock assembly out towards the front of the dashboard. Disconnect the negative battery cable from the battery. The clock should pop right out of its mounting hole. Disconnect the wiring to the back of it.

To install the clock, attach the wiring to the back of it and push it back into its mounting hole until it pops in place. Reconnect the negative battery cable.

Click image to see an enlarged view

Fig. Fig. 1: The clock is mounted behind, and attached to, the instrument cluster