Cobalt 2006-2008, G5 2007

Multi-Function (Combination) Switch

Print

Removal & Installataion



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disable the SIR system. Refer to Air Bag (Supplemental Restraint System), disarming the system.

    Click image to see an enlarged view

    Fig. Remove the Instrument Panel (I/P) center trim panel by releasing the retaining fasteners

  4.  
  5. Remove the Instrument Panel (I/P) center trim panel (1) by pulling out on the trim panel in order to release the retaining fasteners (2).
  6.  
  7. Disconnect the electrical connectors on the Instrument Panel (I/P) center trim panel (1).

    Click image to see an enlarged view

    Fig. Remove the steering column opening filler assembly, with clip, & bumper

  8.  
  9. Remove the steering column opening filler assembly (1) by pulling away the clips (2).
  10.  
  11. Disconnect the electrical connector for the trunk release.

    Click image to see an enlarged view

    Fig. Remove the Instrument Panel (I/P) left side trim panel

  12.  
  13. Remove the Instrument Panel (I/P) left side trim panel (1).
  14.  
  15. Tilt the steering wheel up.
  16.  
  17. Disconnect the I/P dimmer switch and, if equipped, the fog lamp switch.

    Click image to see an enlarged view

    Fig. Remove the 4 bezel screws (2) & the Instrument Panel (I/P) cluster bezel assembly (1)

  18.  
  19. Tilt the steering wheel down.
  20.  
  21. Remove the 4 instrument panel cluster bezel screws.
  22.  
  23. Remove the instrument panel cluster bezel.

    Click image to see an enlarged view

    Fig. Remove the steering column trim covers: steering column upper cover assembly, steering column left cover assembly, & steering column right cover assembly

  24.  
  25. Remove the steering column trim covers:
    1. Remove the 3 cover screws (4).
    2.  
    3. Remove the steering column upper cover assembly (1).
    4.  
    5. Remove the steering column left cover assembly (2).
    6.  
    7. Remove the steering column right cover assembly (3).

      Click image to see an enlarged view

      Fig. Removal of the multi-function switch (1)

    8.  

  26.  
  27. Disconnect the turn signal multifunction switch electrical connector.
  28.  
  29. Depress the locking tabs and remove the turn signal multifunction switch (1).
  30.  

To install:

  1. Install the turn signal multifunction switch (1). Ensure the locking tabs are snapped into place.
  2.  
  3. Connect the turn signal multifunction switch harness connector.
  4.  
  5. Installation is the reverse of removal procedure.
  6.  
  7. Tighten the trim cover screws to 17 inch lbs. (2 Nm)
  8.  
  9. Tighten the 4 instrument panel cluster bezel screws to 19 inch lbs. (2 Nm)
  10.  
  11. Enable the SIR system. Refer to Air Bag (Supplemental Restraint System), arming the system.
  12.  

 
label.common.footer.alt.autozoneLogo