Commander 2006-2007

Mirrors

Print

Power Mirrors



Diagnosis & Testing

NOTE
For complete circuit diagrams, refer to the appropriate wiring information.

  1. Check the fuses in the Power Distribution Center (PDC) and the junction block. If OK, go to step 2. If not OK, repair the shorted circuit or component as required and replace the faulty fuse(s).
  2.  
  3. Check for battery voltage at the fuse in the junction block. If OK, go to step 3. If not OK, repair the open circuit to the PDC as required.
  4.  
  5. Disconnect and isolate the battery negative cable. Remove the driver side power window switch and bezel assembly and unplug the wire harness connector from the power mirror switch. Connect the battery negative cable. Check for battery voltage at the fused B(+) circuit cavity in the door wire harness half of the power mirror switch wire harness connector. If OK, go to step 4. If not OK, repair the open circuit to the junction block as required.
  6.  
  7. Disconnect and isolate the battery negative cable. Check for continuity between the ground circuit cavity in the door wire harness half of the power mirror switch wire harness connector and a good ground. There should be continuity. If not OK, repair open in the ground circuit.
  8.  

Removal & Installation
Switch
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the door trim panel.
  4.  
  5. Remove the power mirror switch from the door trim panel by twisting switch.
  6.  

To install:

  1. Install power mirror switch to door trim panel.
  2.  
  3. Connect wire harness connectors to switches.
  4.  
  5. Install door trim panel.
  6.  
  7. Connect the battery negative cable.
  8.  

 
label.common.footer.alt.autozoneLogo