Commander 2006-2007

Upper Control Arms

Print

Removal & Installation



Left Side
  1. Raise and safely support the vehicle.
  2.  
  3. Place a suitable jack under the axle to support it.
  4.  
  5. Lower the fuel tank in order to gain access to the bolt.
  6.  
  7. Remove the upper suspension arm nut and bolt from the axle bracket.
  8.  
  9. Remove the nut and bolt from the frame rail and remove the upper suspension arm.
  10.  

To install:


NOTE
All torques should be done with vehicle on the ground with full vehicle weight.

  1. Position the upper suspension arm in the frame rail bracket.
  2.  
  3. Install the mounting bolt and nut tighten to 95 ft. lbs. (129 Nm).
  4.  
  5. Position the upper suspension arm in the axle bracket.
  6.  
  7. Install the mounting bolt and nut tighten to 100 ft. lbs. (136 Nm).
  8.  
  9. Raise the fuel tank back into place and secure.
  10.  
  11. Remove the supports and lower the vehicle.
  12.  

Right Side
  1. Raise and safely support the vehicle.
  2.  
  3. Place a suitable jack under the axle to support it.
  4.  
  5. Remove the upper suspension arm nut and bolt from the axle bracket.
  6.  
  7. Remove the nut and bolt from the frame rail and remove the upper suspension arm.
  8.  

To install:


NOTE
All torques should be done with vehicle on the ground with full vehicle weight.

  1. Position the upper suspension arm in the frame rail bracket.
  2.  
  3. Install the mounting bolt and nut tighten to 95 ft. lbs. (129 Nm).
  4.  
  5. Position the upper suspension arm in the axle bracket.
  6.  
  7. Install the mounting bolt and nut tighten to 100 ft. lbs. (136 Nm).
  8.  
  9. Remove the supports and lower the vehicle.
  10.  

 
label.common.footer.alt.autozoneLogo