Corolla 2006-2007

Hydraulic Control Module

Print

Removal & Installation



  1. Drain brake fluid.
  2.  
  3. Remove front fender liner.
  4.  
  5. Remove the grille assembly 2 bolts and clip.
  6.  
  7. Using a screwdriver, disengage the 3 claws and remove the radiator grille.
  8.  
  9. Remove grill assembly.

    Click image to see an enlarged view

    Fig. Removing grille assembly

  10.  
  11. Remove front bumper cover.
  12.  
  13. Remove the 2 screws and 2 clips.
  14.  
  15. Disengage the hook, and remove the bumper cover.
  16.  
  17. Disconnect the fog light connectors, if necessary.

    Click image to see an enlarged view

    Fig. Removing bumper cover

  18.  
  19. Remove 3 headlight assembly bolts.
  20.  
  21. Pull out the headlight assembly LH forward, then disconnect the bracket of body side.
  22.  
  23. Release the claws and disconnect the connectors as shown in the illustration, and remove the headlight assembly LH.

    Click image to see an enlarged view

    Fig. Removing headlight assembly



    Click image to see an enlarged view

    Fig. Removing headlight assembly claw

  24.  
  25. Remove windshield washer jar assembly.
  26.  
  27. Disconnect the actuator connector.

    Click image to see an enlarged view

    Fig. Removing connector

  28.  
  29. Disconnect the 6 brake tubes from the actuator with bracket.
  30.  
  31. Use tags or make a memo to identify the places to reconnect.

    Click image to see an enlarged view

    Fig. Identifying tubes

  32.  
  33. Remove the 2 bolts, nut and the actuator with bracket.
  34.  
  35. Remove brake actuator with bracket.

    Click image to see an enlarged view

    Fig. Removing brake actuator with bracket.

  36.  

To Install:

  1. Installation is the reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo