Corolla 2006-2007

Fuel Pump

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Relieve the fuel system pressure.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable. On vehicles equipped with an air bag, wait at least 90 seconds before proceeding

    Click image to see an enlarged view

    Fig. Pull the pump off the sender unit; the filter is still attached to the pump

     
    Rear seat cushion and floor service hole cover
     
    Access plate-to-fuel tank bolts, then pull out the plate/fuel pump assembly
     
    Fuel pump sender and fuel pump connector
     
    Outlet pipe from the fuel pump bracket
     
    Return hose from the pump bracket
     
    Fuel pump bracket assembly from the fuel tank
     
    Lower side of the fuel pump from the pump bracket
     
    Fuel pump connector
     
    Fuel hose from the fuel pump
     
    Rubber cushion from the pump
     
    Fuel filter from the pump by removing the small clip
     

  6.  

To install:

  1. Install or connect the following:

    New cushion to the fuel pump
     
    Fuel filter and new clip to the fuel pump
     
    Fuel hose to the fuel pump, fuel pump connector and fuel pump to the bracket
     
    Fuel pump bracket assembly to the fuel tank using a new gasket. Bolts: 30 inch lbs. (3 Nm).
     
    Fuel return hose and the fuel outlet pipe to the fuel pump bracket
     
    Fuel pump and fuel pump sender connector
     
    Negative battery cable
     
    Floor service hole cover and rear seat cushion
     

  2.  

 
label.common.footer.alt.autozoneLogo