Corolla 2006-2007

Brake Pads

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove the wheels.
  4.  
  5. Loosen and remove the caliper mounting bolts, then remove the caliper assembly, without disconnecting the brake line. Position it aside.
  6.  
  7. Slide out the old brake pads along with any anti-squeal shims, springs, pad wear indicators and pad support plates.
  8.  

To install:

  1. Install the pad support plates into the torque plate.
  2.  
  3. Install the pad wear indicators onto the pads. Be sure the arrow on the indicator plate is pointing in the direction of rotation.
  4.  
  5. Install the anti-squeal shims on the outside of each pad and then install the pad assemblies into the torque plate.
  6.  
  7. Compress the caliper piston into the bore. For Corolla rear calipers, use tool SST 09719-14020, to rotate the piston clockwise while pressing it into the bore until it locks.
  8.  
  9. Position the caliper back down over the pads.
  10.  
  11. Install and tighten the caliper mounting bolts.
  12.  
  13. Install the wheels. Check the brake fluid level.
  14.  

 
label.common.footer.alt.autozoneLogo