Crossfire, 2004-2005

Wheel Speed Sensor Rotors (Toothed Rings)

Print

Removal & Installation



The ABS tone ring is integrated into the differential halfshaft and is not separately serviceable.

Front
  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Bolts attaching the flange to the steering knuckle
     
    Wheel speed sensor from the steering knuckle
     
    Wheel speed/brake wear indicator wire harness connector from the body mount connector

    Click image to see an enlarged view

    Fig. Wheel speed sensors are located in each wheel knuckle-master cylinder (1), right rear speed sensor (2), left rear speed sensor (3), left front speed sensor (4), ABS hydraulic unit (5) and right front speed sensor (6)

     

  4.  

To install:

  1. Install or connect the following:

    Wheel speed sensor/brake wear indicator wire harness connector to the body mount connector
     
    Wheel speed sensor to the steering knuckle
     
    Bolts attaching the flange to the steering knuckle and tighten to 106 inch lbs. (12 Nm)
     

  2.  

 
label.common.footer.alt.autozoneLogo