Crossfire, 2004-2005

Manual Bleeding


  1. Before servicing the vehicle, refer to the Precautions section.
  3. Bleed only one brake component at a time in the following sequence:

    Fill the master cylinder reservoir with brake fluid
    Open the caliper bleed screws and allow the brakes to gravity bleed
    Close each bleed screw as fluid starts to drip from it
    Top off master cylinder reservoir once more before proceeding
    Attach one end of the bleed hose to the bleed screw and insert the opposite end in a glass container partially filled with brake fluid
    Be sure the end of the bleed hose is immersed in the brake fluid
    Open up the bleeder screw, then have a helper press down on the brake pedal
    Once the pedal is down, close the bleeder screw
    Repeat bleeding until fluid stream is clear and free of bubbles, then move to the next wheel.