Crossfire 2006-2008

Rear Main Seal

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    The rear main seal cannot be replaced separately. The crankshaft end cover and oil seal are replaced as a set.

  2.  
  3. Remove or disconnect the following:

    Transmission
     
    Flywheel
     
    Crankshaft end cover
     

  4.  
  5. Clean the engine block and oil pan sealing surfaces.

    Click image to see an enlarged view

    Fig. Crankshaft end cover assembly



    Click image to see an enlarged view

    Fig. Crankshaft end cover sealant application

  6.  

To install:

  1. Install a bead of sealant as shown on the NEW end cover.
  2.  
  3. Install the end cover. Torque the bolts to 89 inch lbs. (10 Nm).
  4.  
  5. Use Special Tool 9100 and install the real seal into the end cover.
  6.  
  7. Remove the seal installer.
  8.  
  9. Install the following:

    Flywheel
     
    Transmission

    Click image to see an enlarged view

    Fig. Using special tool 9110 (1) to install the seal

     

  10.  

 
label.common.footer.alt.autozoneLogo