Crossfire 2006-2008

Window Systems

Print

Power Window System



Diagnosis & Testing

Before any testing of the Power Window System is performed, the battery should be fully charged. All the wiring harness connectors should be inspected and cleaned, if necessary, to ensure good connections.

  1. If both of the power windows are inoperative, check Fuse 19 in the Underhood Accessory Fuse Block.
  2.  
  3. With the dome lamp on, apply the power window switch in the direction of the failure.
  4.  
  5. If the dome lamp dims, the window track may be jammed. Check for obstructions in the guide tracks or worn weatherstrips causing a binding.
  6.  
  7. If the dome lamp does not dim, proceed with testing of the individual power window system components and circuits. For complete Power Windows System diagnosis, refer to Power Windows Electrical Diagnostics.
  8.  

Removal & Installation
Switch
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the shifter cover trim panel.
  4.  
  5. Disconnect the power window switch harness connector.
  6.  
  7. Squeeze the clips together and remove the power window switch from the shifter cover trim panel.
  8.  

To install:

  1. Install the power window switch to the shifter cover trim panel.
  2.  
  3. Connect the power window switch harness connector.
  4.  
  5. Install the shifter cover trim panel.
  6.  
  7. Connect the negative battery cable.
  8.  

Window Motor & Regulator
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the door interior trim panel.
  4.  
  5. Carefully peel back the door watershield (1) enough to expose the power window motor attachment rivets and harness connector.
    NOTE
    Use caution to properly support the power window motor before drilling rivets.



    Click image to see an enlarged view

    Fig. Peel back the door watershield (1).

  6.  
  7. Disconnect the power window motor harness connector (1).

    Click image to see an enlarged view

    Fig. Drill out the three power window motor attaching rivets (2).

  8.  
  9. Drill out the three power window motor attaching rivets (2).
  10.  
  11. Remove the power window motor from the door.
  12.  

To install:


NOTE
Insure the original mounting hole pattern is used when installing the power window motor.


NOTE
Before installing, lightly grease the gear on the power window motor.

  1. Position the power window motor into the door.
  2.  
  3. Install the three power window motor attaching rivets (2).
  4.  
  5. Connect the power window motor harness connector (1).
  6.  
  7. Install the door watershield (1).
  8.  
  9. Install the door interior trim panel.
  10.  
  11. Connect the negative battery cable.
  12.  

 
label.common.footer.alt.autozoneLogo