Crown Victoria, Grand Marquis, Town Car, 2006-2007

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
  4.  
  5. Remove the instrument panel.
  6.  
  7. Disconnect the electrical connector from the blend door motor/actuator.
  8.  
  9. Remove the four screws holding the blend door actuator to the plenum.
  10.  
  11. Remove the temperature blend door actuator.

    Click image to see an enlarged view

    Fig. Blend door actuator electrical connector



    Click image to see an enlarged view

    Fig. Blend door actuator mounting to plenum

  12.  

To install:

Installation is reverse of removal.

 
label.common.footer.alt.autozoneLogo