Removal & Installation
If the vehicle is equipped with air suspension, the electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the luggage compartment. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these
operations. Failure to follow these instructions may result in personal injury.
On 2005 models, the ball joint is not serviced separately. If the ball joint is faulty the upper control arm and ball joint are replaced as an assembly.
If equipped with air suspension, the air suspension switch to the
position before raising the vehicle.
Place supports under both sides of the frame just behind the lower control arms.
Remove the wheel.
Place a floor jack under the lower control arm at the lower ball joint area. The floor jack will support the spring load on the lower control arm.
Remove the retaining nut and pinch bolt from the upper ball joint stud.
Mark the position of the alignment cams. When replacing the upper ball joint this will approximate the current alignment.
Remove or disconnect the following:
2 nuts retaining the upper ball joint to the upper control arm
Upper ball joint from the upper control arm and spread the slot in the wheel spindle with a pry bar to remove the ball joint stud from the wheel spindle.
Install or connect the following:
Upper ball joint to the upper control arm
Ball stud into the wheel spindle
Upper ball joint pinch bolt and retaining nut. Tighten to 59 ft. lbs. (80 Nm).
Alignment cams to the approximate position at removal. If not marked, install in the neutral positions.
2 nuts retaining the upper ball joint to the upper control arm. Hold the cams and tighten the nuts to 111 ft. lbs. (150 Nm).
Wheel and tire assembly. Tighten the lug nuts in a star pattern to 100 ft. lbs. (136 Nm).
Remove the floor jack from under the lower control arm.
If equipped with air suspension, turn the air suspension switch to the
Check and adjust the front wheel alignment.