Crown Victoria, Grand Marquis, Town Car, 2006-2007

Wheel Bearings



The front wheel bearings are of a hub unit design and are pre-greased, sealed and require no maintenance. The bearings are preset and cannot be adjusted.

Removal & Installation

If the vehicle is equipped with air suspension, the electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the luggage compartment. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow these instructions may result in personal injury.

  1. If equipped, turn the air suspension service switch to the OFF position before raising the vehicle.
  3. Remove or disconnect the following

    Front wheel
    Grease cap from the hub
    Disc brake caliper. Suspend the caliper with a length of wire. Do not let it hang from the brake hose. Discard the disc brake caliper mounting bolts.
    Disc brake rotor. If the factory installed push on nuts are installed, remove them first.
    Wheel hub retainer nut and discard
    Hub and bearing assembly

    Click image to see an enlarged view

    Fig. Wheel bearing and wheel hub assembly



Wheel bearing and wheel hub components:

  1. Brake disc
  3. Brake caliper
  5. Wheel bearing and wheel hub assembly
  7. Wheel bearing and wheel hub assembly bolt
  9. Brake caliper and anchor plate bolt (2 required)
  11. Wheel speed sensor electrical connector

To install:

  1. Install or connect the following:

    Hub and bearing assembly
    New wheel hub retainer nut and tighten to 118 ft. lbs. (160 Nm)
    Disc brake rotor and push on nuts, if equipped
    New grease cap seal
    Disc brake caliper using the 2 new disc brake caliper mounting bolts. Tighten the bolts to 89 ft. lbs. (120 Nm).
    Wheel. Tighten the lug nuts in a star pattern to 100 ft. lbs. (136 Nm).

  3. If equipped with air suspension, turn the air suspension switch to the ON position.
  5. Pump the brake pedal several times to position the brake pads prior to moving the vehicle.
  7. Check the front end alignment.