Crown Victoria, Grand Marquis, Town Car, 2006-2007

Removal & Installation


If the vehicle is equipped with air suspension, the electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the luggage compartment. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow these instructions may result in personal injury.

  1. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
  3. Relieve the fuel system pressure.
  5. Install a hose into the fuel filler pipe and drain or siphon the fuel into a storage tank designed for fuel storage.
  7. Remove any dirt that has accumulated around the fuel pump and fuel lines to prevent the entry of contaminants into the tank during fuel pump removal and installation.
  9. Remove or disconnect the following:

    Fuel supply and return line fittings at the fuel pump using fuel line disconnect tools
    Fuel pump module electrical connector
    6 retaining bolts around the perimeter of the fuel pump module
    Fuel pump module and seal from the fuel tank


To install:

  1. Clean the fuel pump module mounting flange and fuel tank mounting surface.
  3. Install or connect the following:

    New seal and the fuel pump module using care not to damage the inlet filter and fuel sending unit float arm
    6 retaining bolts and tighten to 89 inch lbs. (10 Nm)

    Click image to see an enlarged view

    Fig. Tighten the fuel pump mounting bolts to 89 inch lbs. (10 Nm)

    Fuel pump module electrical connector
    Fuel supply and return lines to the fuel pump module. Pull on the fuel line fittings to verify engagement.

  5. Add a minimum of 10 gallons (38L) of clean fuel to the fuel tank and check for leaks.
  7. Install a Fuel pressure gauge to the Schrader valve on the fuel injection supply manifold.
  9. Connect the negative battery cable.
  11. Cycle the ignition switch from the OFF to ON position 5-10 times for 3 second intervals or until the fuel pressure gauge shows at least 35 psi (241 kPa).
  13. Check for fuel leaks.
  15. Remove the fuel pressure gauge.
  17. Start the engine and recheck for fuel leaks.
  19. Road test the vehicle and check for proper operation.