DeVille, Eldorado, Seville 1999-2005

Arming The System

Print

After the applicable service is concluded, enable the air bag system as follows:

  1. Turn the ignition switch to the LOCK position and remove the key.
  2.  
  3. Install or connect the following:

    Yellow 2-way connector at the base of steering column and secure it with the connector retainer clip. Attach the yellow 2-way connector at the passenger air bag lead and secure it with the connector retainer clip.
     
    Left sound insulator
     
    AIR BAG fuse in the fuse block
     

  4.  
  5. Connect the negative battery cable.
  6.  
  7. Turn the ignition switch to the RUN position and verify that the AIR BAG warning lamp flashes 7 times, then turns OFF .
  8.  


NOTE
If vehicle is equipped with optional Rear Air Bags (AW9) the following steps must be done, to completely enable the SIR system.

  1. Remove the key from the ignition switch.
  2.  
  3. Connect the passenger rear side air bag yellow connector to the vehicle harness yellow connector.
  4.  
  5. Install the CPA to the passenger rear side air bag yellow connector.
  6.  
  7. Connect the driver rear side air bag yellow connector to the vehicle harness yellow connector.
  8.  
  9. Install the CPA to the driver rear side air bag yellow connector.
  10.  
  11. Install the rear seat back.
  12.  
  13. Connect the driver side (seat) air bag and pretensioner yellow connector to the vehicle harness yellow connector.
  14.  
  15. Install both CPA locks to the driver side (seat) air bag and pretensioner yellow connector located under the driver seat.
  16.  
  17. Connect the passenger side (seat) air bag and pretensioner yellow connector to the vehicle harness yellow connector.
  18.  
  19. Install both CPA locks to the passenger side (seat) air bag and pretensioner yellow connector located under the passenger seat.
  20.  
  21. Connect the passenger (IP) frontal air bag yellow connector to the vehicle harness yellow connector located above the passenger sound insulator.
  22.  
  23. Install the CPA to the passenger yellow connector.
  24.  
  25. Install the passenger sound insulator.
  26.  
  27. Connect the driver frontal air bag yellow connector to the vehicle harness yellow connector located next to steering column.
  28.  
  29. Install the CPA to the driver yellow connector.
  30.  
  31. Install the driver sound insulator.
  32.  
  33. Install the SIR fuse to the rear fuse block.
  34.  
  35. Install the rear seat.
  36.  
  37. Turn the ignition switch to the RUN position and verify that the AIR BAG warning lamp flashes 7 times, then turns OFF .
  38.  

 
label.common.footer.alt.autozoneLogo