DeVille, Eldorado, Seville 1999-2005

Wheel Speed Sensor Rotors (Toothed Rings)

Print

Removal & Installation



Front
  1. Raise the vehicle and support the frame with jack stands.
  2.  
  3. Remove the tire and wheel assembly
  4.  
  5. Remove the hub nut and washer.
  6.  
  7. Remove the caliper.
  8.  
  9. Remove the caliper support.
  10.  
  11. Remove the rotor.
  12.  
  13. Separate the drive axle from the hub.

    Click image to see an enlarged view

    Fig. Typical location of front wheel speed sensor.

  14.  
  15. Remove the hub and bearing retaining bolts.
  16.  
  17. Disconnect the ABS wheel speed sensor connector from the hub and bearing assembly.
  18.  
  19. Remove the wheel bearing and hub.

    Click image to see an enlarged view

    Fig. The front wheel speed sensor is part of the hub and bearing assembly.

  20.  

To install:

  1. Connect the ABS wheel speed sensor connector to the hub and bearing assembly.
  2.  
  3. Connect the hub and bearing assembly to the knuckle.
  4.  
  5. Tighten the hub and bearing retaining bolts to 70 ft. lbs. (95 Nm).
  6.  
  7. Install the caliper and support the caliper using new caliper mounting bolts.
  8.  
  9. Install the rotor.
  10.  
  11. Partially tighten the hub nut and washer.
  12.  
  13. Install the tire and wheel assembly.
  14.  
  15. Tighten wheel nuts to 100 ft. lbs. (136 Nm).
  16.  
  17. Lower the vehicle.
  18.  
  19. Tighten the hub nut to 110 ft. lbs. (150 Nm).
  20.  

 
label.common.footer.alt.autozoneLogo