Dodge Colt/Challenger/Conquest/Vista 1971-1989 Repair Guide

Rear Window Stationary Glass

Print

REMOVAL & INSTALLATION



  1. Remove any trim panels as necessary to gain access to the glass pane.
  2.  
  3. If removing the quarter glass, remove the nuts holding the glass module to the quarter glass opening.
  4.  
  5. Cut the urethane sealer around the perimeter of the glass opening fence.
  6.  
  7. Lift the glass module out of the glass opening. Separate the glass module from the vehicle.
  8.  

To install:

  1. Clean all surfaces of the opening, fence and glass module.
  2.  
  3. Prepare the fence and glass module using the same method as described in the windshield removal and installation service procedures earlier in this section.
  4.  
  5. Install the window into the opening.
  6.  
  7. If applicable, install the nuts to hold the quarter glass module in the opening.
  8.  
  9. Wipe excess urethane from around the window, then install the quarter window molding and trim panel.
  10.  
  11. Allow adequate time for the urethane to cure before driving the vehicle. For more details, refer to the windshield removal and installation procedure earlier in this section.
  12.  

 
label.common.footer.alt.autozoneLogo