REMOVAL & INSTALLATION
Remove the hold-down screws for the cap.
Lift the cap off the distributor.
Tag the wires and cap before removing them, then disassemble.
Install the new cap.
Attach the tagged wires on the cap.
Fig. Fig. 1 On some engines, when removing the wires from the cap, you may need to use pliers to squeeze the electrode, then push through the opening of the cap
Fig. Fig. 2 On other engines use your fingers and grasp around the plug nipple, then pull
Fig. Fig. 3 Remove the hold-down screws for the cap
Fig. Fig. 4 Lift the cap off the distributor